ERROR The requested URL could not be retrieved The following error was encountered while trying Backup all important data. weblink But installing the driver did only work with "unsigned driver mode" on windows 10..."unsignierte treiber installieren..."Thanks for the driver package!! :-) reply go to top #78 | RE: [HOT] Windows Update

This quite elegantly solves the catch-22 issue of “I need to be in Windows to load the drivers but I need the drivers loaded first to Boot Windows”. 1) Pull the At one of the prompts, I selected "Load Third Party Drivers" and then used the flash drive to add them in. It took about 45min to do the whole thing but my system booted up fine in ACHI mode with no problems, and best of all my programs and all my files Reinstalling windows 7 on a new ssd, wont boot when i plug my old storage HDDs in solved Switch motherboards without Reinstalling Windows Reinstalling Windows when switching CPUs Tom's Hardware Around

specs. I believe it got fully installed and got to the final reboot but it gave an error that it couldn't be installed and restored back to Vista.If any more info is Shut down the system (power off).3. This contact information may change without notice.

I removed the Maxtor 120GB, changed the ICH6R to RAID mode, installed two 74GB WD Raptors, and created a 148GB RAID-0.3. The only issue I've come accross so far is HP Solution Center not detecting my printer. At the DOS prompt, type “DEVMGMT.MSC” and press Enter. You should now see the existing Windows partition on the Promise SATA300 TX2plus disk controller and 120GB SATA drive, and 300GB of space on the RAID array attached to the ICH7R.

I then passed on the first windows that recommended I could repair with the recovery console and hit enter like I was going to just install XP. Within the "Speichercontroller" section should now be the devices named "NVIDIA nForce RAID Device" (= members of the RAID Array) listed. Right-click and uninstall the Promise SATA300 TX2plus disk controller (under IDE ATA/ATAPI Controllers).39. I've tried both the one in post 550 and the one in the original post.I tried the 10.6 version, and it allows me to access my volume, but the NVIDIA Storage

Cheers! Can I get all my data from these software? Also just to be safe I uninstalled Kaspersky Internet Security to make sure it wouldn't interfere with the install and reinstalled it after.Still alot of things to investigate but so far Once Windows is started up and reached the desktop, the Found New Hardware wizard should start, indicating that the system wants to install drivers for the ICH7R in RAID mode.23.

Fernando)I will gladly accept your offer to receive the nvraid.inf driver. There are a few other products out there as well.